ZONESTAR ZRIB Controller Board Motherboard Mainboard Adopt ATMEGA 2560 MCU Compatible for RAMPS 1.4 RepRap Mendel i3 FDM 3D Printer DIY Self Assembly Parts
ZONESTAR ZRIB Controller Board Motherboard Mainboard Adopt ATMEGA 2560 MCU Compatible for RAMPS 1.4 RepRap Mendel i3 FDM 3D Printer DIY Self Assembly Parts by ZONESTAR at 3D Printing Supplies Outlet. MPN: EYN6928675770737AI. Hurry! Limited time offer. Offer valid only while supplies last. ZONESTAR ZRIB control board is the combination of MEGA2560 plus RAMPS1.4 and A4982 in 3D printer. It is a feature rich all-in-one electronics
A combination of MEGA2560 + RAMPS1.4 + 5 Motor drivers.
Firmware can use the same configuration as RAMPS1.4.
Support 3D machine upgrade into dual extruders and light engraver.
Support upgrade with filament run-out detect and resume function.
One of the driver can connect to two Z motors.
4 PWM capable power mosfet outputs with 12 - 24V wide voltage range for MainPower.(Bed, Extruder0, Extruder1, Fans)
Recoverable fuse for short-circuit protection.
USB driver chip is CP2012.
Voltage: 12V - 24V
Item Size: 11 * 9.5cm / 4.3 * 3.7" (L * W)
Item Weight: 77g / 2.7oz
Package Size: 11.5 * 10 * 2.5cm / 4.5 * 3.9 * 1"
Package Weight: 79.5 * 2.8oz
1 * Control Board
1. Before power on, please make sure that the positive and negative is not reversed.
2. Do not plug when the motor and drive is powered on, drive easily lead to burn; do not adjust the current when the motor is running. Disconnect the power first, unplug the motor, and then re-power, adjust potentiometer, measure the voltage on the potentiometer until the measured voltage is the same as expected. Do not insert anti-drive, otherwise it will burn drive, or even burn out the motherboard.
Features & Highlights
- A combination of MEGA2560 + RAMPS1.4 + 5 Motor drivers; Z driver can connect to 2 motors.
- MEGA compatible for Atmega2560 processors and for all RAMPS classics firmware.
- Compatible for dual-extrude printer, support upgrade into light engraver and filament run-out detect and resume function.
- Easy DISPLAY + SD-CARD connector, RepRap Discount Smart Controller compatible pin header on board.
- 3 temperature ADC connectors for thermistor; 2 Fan control connector and 1 board cooler connector; 4 PWM capable power mosfet outputs with 12 - 24V wide voltage range for MainPower. 6 endstop connectors Xmin/Xmax/Ymin/Ymax/Zmin/Zmax; USB driver chip is CP2012.
|Package Weight:||0.26 pounds|
|Package Size:||5.35 x 1.18 x 1.18 inches|